This is for applying to a car, window or mirror. If applying to a water bottle or laptop you can exclude using water to help apply your decal.

Care Instructions for Your Decal

How to apply your decal

Things you will need:

1. Spray bottle with soapy water
2. Towel
3. Squeegee or credit card

Steps:

1. Clean and dry your area.
2. Once you decide where to place your decal, spray the area.
3. Slowly peel your decal.
4. Since the area is wet, you can move your decal to the desired spot.
5. With your squeegee, smooth out the area from the middle outwards to apply evenly and remove bubbles.
6. Spray again to help remove the transfer tape.
7. Slowly peel the back of the transfer tape flush against the window.
8. Dry the area.
9. Done!

DISCLAMER

Wet application is not recommended when the applying surface is cold. Cold surfaces may prevent moisture from evaporating. Wait for surface to be above 70˚F or carefully warm the surface using caution to not overheat the surface.

How to remove your decal

Things you will need:

1. Heat gun or hair dryer

Steps:

1. Use the lowest heat setting and while quickly moving the heat gun in a circler motion, apply even heat to the whole area. It should be warm to the touch, not hot.
2. Start from a corner and slowly peel up the decal.
3. Wipe off any sticky residue.
4. Done!